Category: AdderLink Infinity

__Prerequeistes__
This update requires that the AIM Manager is running v4.12 or above.

__New Features__
*The 3rd copper network interface can be Static or allocated DHCP. This is set via the AIM

Changes since 4.02 f/w:

__Changes since 6.06 f/w:__
*Last frame frozen and UI notification feature
*Auto Logout feature
*Use saved monitors EDID feature
*Rebooting RX should not cause TX to lose USB descriptor
*Laggy mo

Changes since 1.0 f/w:
- Fixed: Updating of the UI Settings failed, triggering a RETRY and CONFLICT before updating
- Fixed: USB not functional when ALIF4000 RX is connected to ALIF TX (ALIF1002, AL

Changes since 3.01 f/w:
*Added a workaround for an error in the EDID of a LG Ultrawide 38UC99 monitor (3840 x 1660) which did not display video unless active sync is enabled.
*Rebooting the AIM Mana

Changes since 5.05 f/w:
*Need to turn auto negotiate to OFF(None) for SFP’s on network switches
*RX unable to communicate with TX in multi subnet matrix (Self-managed mode)
*DHCP classless routes

Changes since 3.01 f/w:
*Extended channel hotkeys (0-99). Requires AIM version v4.11.45021
*Support for Channel Banner positioning from AIM.
*Device status for the DP Audio and Transparent USB co

Changes since 1.1 f/w:

__New Feature:__
*Transparent USB2.0 High-speed link The ALIF4000 contains hardware that allows a full 480Mbps USB2.0 high-speed point to point link to be formed. In this V2

Changes since 1.1 f/w:

__New Feature:__
*Support for 5k resolutions, including
**5120 x 2880@30hz
**5120 x 2160@30hz
**5120 x 1440@60hz
*High Frame Rate Support. Up to 240Hz (1920x1080)
*Di

We have had some instances where endpoints were not being seen properly by AIM when using a Cisco 3850 switch. Upon investigation, it was discovered that if the interfaces are left as default (i.e. no