Changes since 1.1 f/w:
- Transparent USB2.0 High-speed link The ALIF4000 contains hardware that allows a full 480Mbps USB2.0 high-speed point to point link to be formed. In this V2.02 release, this feature has been enabled. This is identified as port 1 on the front of the RX unit. The link is point to point only. It cannot be multicast. In terms of setup and operation, it is linked to the normal USB operation. In a matrix system, the first RX to connect to the TX gets the link. If a second RX joins, the high-speed link is not active. If the original RX disconnects, the second unit that joined will assume the link. The HID only feature also disables the high-speed link totally as well as the normal USB from using any device other than HID devices.
- Point to point setup via OSD. In point to point mode, it is now possible to configure all the RX and TX units setting from the onboard OSD. By using the hotkey modifier (Left ALT, Left CTRL, C default setting) this brings up the OSD and allows the user to configure.
- USB device support. Support has been added for smart card or CAC readers and support for extra classes of Serial to USB devices.
The firmware release is available from our main website using the link below:-
This firmware release may have been superseded and no longer available for download. Always check to make sure that you are running the latest firmware version. The version was correct at the time of writing this article.