Category: Digital Matrix

The ALIF3000 can only be upgraded via the AIM Manager. We are aware of any issue with AIM v4.11 and below where an upgrade will unexpectedly fail. Make sure that you have not set the AIM to __Use SSL_

Changes since 1.0.1:
*Added Microphone support for RDP
*Added feature to make the banner movable to 6 positions
*Backup firmware version was not reported to AIM.
*Audio volume was not set correctl

__Prerequeistes__
This update requires that the AIM Manager is running v4.12 or above.

__New Features__
*The 3rd copper network interface can be Static or allocated DHCP. This is set via the AIM

Changes since 4.02 f/w:

Changes since 1.0 f/w:
- Fixed: Updating of the UI Settings failed, triggering a RETRY and CONFLICT before updating
- Fixed: USB not functional when ALIF4000 RX is connected to ALIF TX (ALIF1002, AL

Changes since 3.01 f/w:
*Added a workaround for an error in the EDID of a LG Ultrawide 38UC99 monitor (3840 x 1660) which did not display video unless active sync is enabled.
*Rebooting the AIM Mana

Changes since 3.01 f/w:
*Extended channel hotkeys (0-99). Requires AIM version v4.11.45021
*Support for Channel Banner positioning from AIM.
*Device status for the DP Audio and Transparent USB co

Changes since 1.1 f/w:

__New Feature:__
*Transparent USB2.0 High-speed link The ALIF4000 contains hardware that allows a full 480Mbps USB2.0 high-speed point to point link to be formed. In this V2

Changes since 1.1 f/w:

__New Feature:__
*Support for 5k resolutions, including
**5120 x 2880@30hz
**5120 x 2160@30hz
**5120 x 1440@60hz
*High Frame Rate Support. Up to 240Hz (1920x1080)
*Di

After January 2018, it is not possible to add new or factory reset endpoints to the AIM Manager due to a 32-bit rollover problem when generating 30 year SSL Certificates. They are required by both the

Changes since 4.9 f/w:
*Adds support for ALIF4000 V3.0 release which includes
**DisplayPort Audio – up to 8 channels on both heads
**Independent control of the transparent high-speed USB
**Sup

Changes since f/w v4.11.45012:
*After upgrading to 4.11, some receiver models (ALIF1002R, ALIF2020R, ALIF2000R) that were disconnected and were not previously running v4.9 firmware, will be completel

Changes since 4.11 f/w:
*Clearer on-screen instructions for RDP Login credential page for ALIF3000
*Removal of RDP transmitters from statistics page as they are not applicable
*Long Receiver names

This is update is for AIM-XX and ASP-001

Changes since v4.12/v4.13
- DeviceDaemon logging modified to prevent excessive log files sizes.
- System packages updated for Upgrade system for future re

''text''