Category: AdderLink Infinity

__Changes since v8.05__
*1G Optical SFP fails with some network switches

For a full list of fixes and known issues, please read the release notes.

Changes since 1.0 f/w:
- Fixed: Updating of the UI Settings failed, triggering a RETRY and CONFLICT before updating
- Fixed: USB not functional when ALIF4000 RX is connected to ALIF TX (ALIF1002, AL

Changes since 1.1 f/w:

__New Feature:__
*Transparent USB2.0 High-speed link The ALIF4000 contains hardware that allows a full 480Mbps USB2.0 high-speed point to point link to be formed. In this V2

We have had some instances where endpoints were not being seen properly by AIM when using a Cisco 3850 switch. Upon investigation, it was discovered that if the interfaces are left as default (i.e. no

Fixes two issues from 4.5; losing USB with certain HP machines on reboot and having two transmitters video pointing to one receiver.

Be careful if you are using the 192.168.1.x network range for endpoints. We have seen a problem where if an endpoint is given 192.168.1.42, it cannot be added to the AIM Manager. This is because 192.1

Known to affect 4.x firmware.

When configuring the AIM's web interface, it is recommended that you use an up to date web browser. If using Internet Explorer 11 or below, configuration pages like th

After January 2018, it is not possible to add new or factory reset endpoints to the AIM Manager due to a 32-bit rollover problem when generating 30 year SSL Certificates. They are required by both the

''text''

FIxes:
- ALIF100T-VGA could not be added to the AIM Manager.