Category: AdderLink Infinity

Changes since 1.0 f/w:
- Fixed: Updating of the UI Settings failed, triggering a RETRY and CONFLICT before updating
- Fixed: USB not functional when ALIF4000 RX is connected to ALIF TX (ALIF1002, AL

Changes since 1.1 f/w:

__New Feature:__
*Transparent USB2.0 High-speed link The ALIF4000 contains hardware that allows a full 480Mbps USB2.0 high-speed point to point link to be formed. In this V2

We have had some instances where endpoints were not being seen properly by AIM when using a Cisco 3850 switch. Upon investigation, it was discovered that if the interfaces are left as default (i.e. no

Fixes two issues from 4.5; losing USB with certain HP machines on reboot and having two transmitters video pointing to one receiver.

Fixes an intermittent loss of USB, particularly when used in conjunction with a CCS-PRO. Requires CCS-PRO firmware upgrade.

V4.9 is a maintenance release which has addressed issues with the OSD (On screen display) and USB support of newer devices.
One new feature is the ability to stack the dual screen view via VNC on the

__Products__
This firmware update is for the ALIF1002T/R, ALIF2000T/R, ALIF2002T, ALIF2020T/R and ALIF2112T

__Changes since version v4.9__
*Fixed support for Elgato Stream Deck on latest software

Be careful if you are using the 192.168.1.x network range for endpoints. We have seen a problem where if an endpoint is given 192.168.1.42, it cannot be added to the AIM Manager. This is because 192.1

Known to affect 4.x firmware.

When configuring the AIM's web interface, it is recommended that you use an up to date web browser. If using Internet Explorer 11 or below, configuration pages like th

After January 2018, it is not possible to add new or factory reset endpoints to the AIM Manager due to a 32-bit rollover problem when generating 30 year SSL Certificates. They are required by both the

''text''