Note: It is not possible to downgrade once upgraded.
Changes since v1.04
Fixed: DP1 Link Oversubscribed error when monitors are reconnected to a MST hub
Fixed: Missing video when local display is connected to a MST transmitter
Fixed: Local TX monitor may not work if attached at boot up
Fixed: OSD can be shown with the wrong colour format
Fixed: EDIDs are no longer restricted to 8-bit colour
Fixed: Resolution mismatch reported for valid mode
Fixed: Mouse scroll wheel events are not passed to host PC
Fixed: DP1 video disappears too when DP2 cable disconnected.
Download
The firmware release is available from our main website using the link below:-
Firmware v1.11
Note
This firmware release may have been superseded and no longer available for download. Always check to make sure that you are running the latest firmware version. The version was correct at the time of writing this article.