Categories

*TX local feed-through daisy chain with Dell U2415 DP1.2 video doesn’t recover if the TX is rebooted
*Local video timings are not calculated correctly if the source video was not connected.
*Video

*Upgrade failure observed about 1 in 5 attempts
*Local video timings are not calculated correctly if the source video was not connected.
*XD614 Video loss after a period time-Link led on RX blinking

Changes since 1.04 f/w:
*Resolved: DP1 Link Oversubscribed error when monitors are reconnected to a MST hub
*Resolved: Missing video when local display is connected to a MST transmitter
*Resolved:

*Local Video timings are not calculated correctly
*Video loss after being in use for a period of time
*Restarting a Mac can cause the Tx to crash

Changes since 1.04 f/w:
*The monitor's EDID is manipulated if reported above 8-bit colour to ensure compatibility.
*Resolved: Mouse scroll wheel events are not passed to host PC
*Added support for

*Local Video timings are not calculated correctly
*Video loss after being in use for a period of time
*Restarting a Mac can cause the Tx to crash

Changes since 1.04 f/w:
*Fixed: Video occasionally blanks out
*Fixed: Displays sometimes lost upon server reboot
*Fixed: Mouse scroll wheel events are not passed to host PC
*Added support for Barc

__Changes since 1.03__
This release does not contain any fixes, just support for a newer flash memory chip.

Changes since f/w: 1.04
*Extended size of matrix.
**Each Receiver can now connect to a maximum number of 16 transmitter units
**Each Transmitter unit can now be connected to 256 receiver units
*Op

Fixes since f/w: 1.06
*You can now enable "Remote Control” or change the ”Static IP address” configuration settings. The changes could not be saved on the v1.06 firmware.