Category: AdderLink Infinity

Changes since 4.02 f/w:

__Changes since 6.06 f/w:__
*Last frame frozen and UI notification feature
*Auto Logout feature
*Use saved monitors EDID feature
*Rebooting RX should not cause TX to lose USB descriptor
*Laggy mo

Changes since 1.0 f/w:
- Fixed: Updating of the UI Settings failed, triggering a RETRY and CONFLICT before updating
- Fixed: USB not functional when ALIF4000 RX is connected to ALIF TX (ALIF1002, AL

Changes since 3.01 f/w:
*Added a workaround for an error in the EDID of a LG Ultrawide 38UC99 monitor (3840 x 1660) which did not display video unless active sync is enabled.
*Rebooting the AIM Mana

Changes since 5.05 f/w:
*Need to turn auto negotiate to OFF(None) for SFP’s on network switches
*RX unable to communicate with TX in multi subnet matrix (Self-managed mode)
*DHCP classless routes

Changes since 3.01 f/w:
*Extended channel hotkeys (0-99). Requires AIM version v4.11.45021
*Support for Channel Banner positioning from AIM.
*Device status for the DP Audio and Transparent USB co

Changes since 1.1 f/w:

__New Feature:__
*Transparent USB2.0 High-speed link The ALIF4000 contains hardware that allows a full 480Mbps USB2.0 high-speed point to point link to be formed. In this V2

Changes since 1.1 f/w:

__New Feature:__
*Support for 5k resolutions, including
**5120 x 2880@30hz
**5120 x 2160@30hz
**5120 x 1440@60hz
*High Frame Rate Support. Up to 240Hz (1920x1080)
*Di

We have had some instances where endpoints were not being seen properly by AIM when using a Cisco 3850 switch. Upon investigation, it was discovered that if the interfaces are left as default (i.e. no

After January 2018, it is not possible to add new or factory reset endpoints to the AIM Manager due to a 32-bit rollover problem when generating 30 year SSL Certificates. They are required by both the